Specifications:

Chip: Epistar

Voltage: 10- 30 V

Watt：1.4W

CRI: ≥80

CCT: 2800-3200k

Switch: Touch & Dimmable switch

Material: Iron

Finish: Chrome

Operating Voltage: 12V DC

Lighting color: Warm White

Luminous Flux: 120 lumens

Lighting Angle: Adjustable 90°，350°spin

Switch: Touch dimmer switch, dimming range 15%-100%.

Surface Mount：Mounting screws included, no hole, no cutting, no damage to install the surface

Base Diameter: 2.3 inch / 60mm

Irradiation area:1-3 m²

USB output voltage: 5V

USB output current:2A

Advantages:

✔ 1.4W, 10-30V Voltage.

✔ Solid acrylic lens shade.

✔ 92 lumens which is bright enough for reading.

✔ Surface mount, only need screw fixing, no need to make hole.

✔ The life of LED lamp bead is about 30,000 hours, under normal use condition.

✔ The Memory Function ensures you don’t have to reset it; set it once and the dimmer will remember it.

✔ IP20 ( but don't soak it in the water ) to fully protect circuit safety, prevent accidental leakage.

Application:

✔This low power reading Light can be widely decorated in the auto, used for daily lighting, lighting a wide range and adequate lighting.

✔The use of aluminum and pmma, has a Anti-seismic, corrosion-resistant capability.

✔1.4W power can not only protect lighting needs but will not lose too much electricity, can be widely used in small areas or mobile places, such as boathouse, motorhouse, campers, travel car, touring bus, tour bus, tourist Bus.

✔This upscale bedside reading lamp is packaged by a fine paper barrel. You can DIY this box, if you have good ideas, welcome communicate with us.